I have followed some instructions online to try to flip my screen orientation from landscape to portrait, but it seems the ubuntu-frame does not recognize it.
Here is my display config:
default: cards: - card-id: 0 DisplayPort-1: # (disconnected) HDMI-A-1: # (disconnected) DisplayPort-2: # This output supports the following modes: 1920x1080@60.0, 1920x1080@59.9, # 1920x1080@30.0, 1920x1080@30.0, 1920x1080@50.0, 1920x1080@25.0, 1280x1024@60.0, # 1440x900@59.9, 1280x800@59.8, 1280x720@60.0, 1280x720@59.9, 1280x720@50.0, # 1024x768@60.0, 800x600@60.3, 800x600@56.2, 720x576@50.0, 720x480@60.0, # 720x480@59.9, 640x480@66.7, 640x480@60.0, 640x480@59.9, 720x400@70.1 # # Uncomment the following to enforce the selected configuration. # Or amend as desired. # state: enabled # {enabled, disabled}, defaults to enabled mode: 1080x1920@60.0 # Defaults to preferred mode position: [0, 0] # Defaults to [0, 0] orientation: right # {normal, left, right, inverted}, defaults to normal scale: 1 group: 0 # Outputs with the same non-zero value are treated as a single display HDMI-A-2: # (disconnected) DisplayPort-3: # (disconnected) HDMI-A-3: # (disconnected) side_by_side: cards: # a list of cards (currently matched by card-id) - card-id: 0 DisplayPort-1: # (disconnected) HDMI-A-1: # (disconnected) DisplayPort-2: # This output supports the following modes: 1920x1080@60.0, 1920x1080@59.9, # 1920x1080@30.0, 1920x1080@30.0, 1920x1080@50.0, 1920x1080@25.0, 1280x1024@60.0, # 1440x900@59.9, 1280x800@59.8, 1280x720@60.0, 1280x720@59.9, 1280x720@50.0, # 1024x768@60.0, 800x600@60.3, 800x600@56.2, 720x576@50.0, 720x480@60.0, # 720x480@59.9, 640x480@66.7, 640x480@60.0, 640x480@59.9, 720x400@70.1 # # Uncomment the following to enforce the selected configuration. # Or amend as desired. # state: enabled # {enabled, disabled}, defaults to enabled mode: 1080x1920@60.0 # Defaults to preferred mode position: [0, 0] # Defaults to [0, 0] orientation: right # {normal, left, right, inverted}, defaults to normal scale: 1 group: 0 # Outputs with the same non-zero value are treated as a single display HDMI-A-2: # (disconnected) DisplayPort-3: # (disconnected) HDMI-A-3: # (disconnected)```I tried restarting it several times, used different orientations, resolutions but it stays the same.I am using ubuntu-frame on top of my desktop 22.04LTS release.Obviously I wanted to post on Ubuntu Frame Discourse but it says it's not technical support and I cannot create a new topic. 